FallTech SteelGrip Temporary Cable HLL System and Stanchions with 12" beam clamps

SteelGrip Cable Horizontal Lifeline and Stanchion Systems provide temporary, portable and continuous anchoring for worksite conditions where typical anchorages along a walking surface are limited or nonexistent. SteelGrip HLLs can be configured as single or multi-span systems adapting to specific user’s anchoring needs.

Features:

• Pre-configured in 30´ and 60´ single-span and 80´ and 100´ multi-span systems
• Single-span systems include one Coil Energy Absorber and two Stanchions while Multi-span systems
• 42" Plated Steel I-Beam Stanchions fit beam flanges up to 2¼" thick
• Plated Steel I-Beam Clamps available with flange width ranges of 4" to 12", 4" to 18" and 4" to 24" and include Steel Wing Nut adjusters

Materials Specifications:

• Cable Lifeline: 3/8" Galvanized Steel 7x19 5,000 lbs Min Static Strength
• I-Beam Stanchion: Plated Steel Post, Base and Clamp 8,000 lbs Min Static Strength
• Carabiner: Plated Alloy Steel 5,000 lbs Min Static Strength with 3,600 lbs Gate Strength
• Turnbuckle: Galvanized Steel
• Shackle: Galvanized Steel 
• Coil Energy Absorber: Stainless Steel

All SteelGrip Cable HLL Systems include:

• SteelGrip Stainless Steel Coil Energy Absorber (1 or 2 as needed)
• SteelGrip I-Beam Stanchions (2 or 3 as needed)
• Intermediate Pass-through Bracket (for multi-span systems only)
• 21¾" Galvanized steel jaw and jaw Tensioning Turnbuckle with 12" adjustment
• 2 Alloy Steel Carabiners and Wire Rope Clips (plus Steel Shackle for systems greater than 60´
• 3/8" Galvanized Steel Cable with thimble-eye termination

Relevant Standards:

OSHA: 1926.502 and 1910.14

Warnings:

• Read, understand and follow all labels and  instructions prior to use.
• Inspect before each use.
• Remove from service if there is evidence of damage or excessive wear.

Sold/Kit